Analog and Digital Trainer
Product Code : EL-ELE-13530
Solder- less bread board
DC power supply
- Fixed DC output : ±5V,±12V@500mA
- Variable DC output : Dual,0~30V,0~-30V@500mA
- AC power supply : 5~0~5VAC,12~0~12VAC
- Potentiometers : 1KΩ 10KΩ
- Function generator
- Sine wave output : 0 ~ 6Vpp variable@1Hz ~1MHz in stepof 5
- Triangle wave output : 0~6Vppvariable@1Hz~300KHz in stepof5
- Square wave output : 0 ~ 5Vpp variable@1Hz ~ 400KHz in step of 5
- TTL mode output : 5V@1Hz~1MHz in step of 5
Two digits of 7segment LED display
Two pulse switch
- Push buttons to generate inverting and non inverting pulses supported with de-bounce elimination Data switches
- Toggle switches and corresponding output point. When switch is set at “Down” position, the output is LOlevel, contrarily it is to be 'High' level while setting at “Up” position
Speaker
- 8Ω/0.5W to be used for load Four channel adaptor
- The two banana sockets and BNC jacks suitable for the trainer to be connected with peripherals Sixteen bits LED display
- Red LEDs separate input terminals. The LED will be lighted up when input is at “High level” and it will be turned OFF when it is at “NoInput” or at “Lowlevel”
ZIF sockets
- 40pin, 28pin, 20pin