DC servo with industrial DC machine Manufacturer,Supplier and Exporter in China
Product Code : EL-ELE-17691
Objectives
-
Optimising control loops
-
2 and 4 quadrants control
-
Static speed control
-
Dynamic speed control
-
Highly dynamic speed control
-
Position control
-
Step response
-
Calculating the control difference
-
Analyzing loads with step of reference variable
-
Approaching stability limits Highlights:
-
The measurements care carried out with the CASSY converter controller.
-
All measurement channels are potential-free and can therefore be used freely.
-
All measurements can be carried out with or without a computer.
-
In order to protect against overheating the stator windings of the direct current machine are equipped with thermal detectors.
-
The direct current parallel machine has a didactic designed terminal board with the winding configuration "printed on it.
-
Converter Controller is fully controllable in real time via RJ45 Ethernet, W-LAN and USB-C interfaces.
These interfaces can be used by the following software:
-
CASSY Lab 2 for drives and energy systems,
-
MATLAB® and LabVIEW ™
-
Lab Docs Editor Advanced Topics
-
Coupling of motor and commutation encoder
-
Stationary behaviour
-
Measurement of the motor current
-
Variation of the modulation frequency
-
Dynamic behavior
-
Structure of the control
-
Investigation of the angular acceleration depending on the maximum limit current
-
Position control with and without subordinate current and speed controllers
-
Investigation of positioning time and overshooting depending on speed and current limits and ramp time COMPONENTS OF EQUIPMENT SETS
-
1 DC motor based on the specified power supply range. 1 Converter Controller CASSY
-
1 Connecting cable universal converter
-
Four-quadrant operation of a direct current machine with an IGBT-H bridge circuit
-
1 DC power supply 390 V, 6 A, (PFC)
-
1 interface software for Drives and Power Systems Prime mover:
-
1 Compound machine, 0.3"
-
Speed and position sensor: 1 Incremental tacho, 0.3
-
1 Machine base bench, 90 cm
-
1 Machine base bench, 120 cm
-
2 Coupling / shaft end guard 0.3, transparent 1 Coupling, 0.3
-
Required for the position control: 1 Gear, 0.3
-
1 Coupling / shaft end guard 0.3, transparent 1 Coupling, 0.3
Power supply:
-
1 Single-phase terminal unit 1 Panel frame, two-level
-
1 Safety bridging plugs, black, set of 10
-
1 Safety bridging plugs, yellow/green, set of 10 1 Safety experiment cables, 32 A, set of 34
-
1 Safety experiment cables, 32 A, yellow/green, set of 5