PLC Operated Temperature Flow Level Pressure Vibration & Weight Measurement Trainer Manufacturer,Supplier and Exporter in China
Product Code : EL-ELE-16282
- Metal holder with Plexiglas vertical panel
- 3 tanks: lower one in ABS, about 12 lt. capacity; upper one
- (Plexiglas column), 5 lt; side one in steel, 1 lt.
- Recirculation pump, 6 lt/min 12 V - 7A
- Manual valves
- 48 V 200 W water heater
- Safety thermostat
- 1 mercury glass thermometer (-20 °C a + 110 °C)
- 2 Proportional valves, bronze body 0-10 V
- 2 manometers 0-4 bar
- External unit connection with 4 mm diameter terminals and
- DIN connectors
- ON/OFF solenoid valve
- Flow sensors: 1 turbine-type, 1 magnetic-type for ON/OFF
- control
- Level sensors: 1 ON/OFF-type, 1 piezometric-type
- Temperature sensors: 1 Pt100-type, 1 thermocouple J-type, 1
- PTC-type, 1 NTC-type.
- Pressure sensor: 1 piezometric-type, 1 ON/OFF-typeTabletop metal box with press-formed aluminium section
- structure
- Side handles , not protruding, for easy transport in the
- laboratory
- Front panel, in insulating material, with silk screen
- representation of the diagrams and inner components of the
- equipment
- 24 Vdc/3 A power supply for control of the digital inputs and
- outputs. With electronic protection against short-circuits and
- overloads.
- 24 Vac/3 A power supply relay outputs control with fuse
- protection against overloads
- 1 3 and 1/2-digit digital voltmeter for measurement of the
- voltage present across the inputs or the analog output 0.1
- Vdc resolution.
- 1 Rotating switch for voltmeter input selection
- 4 analog inputs V/I: ±10 Vdc, ±20 mA
- 1 input for Pt 100 temperature probe
- 2 analog outputs V/I: ±10 Vdc, ±20 mA
- 4 Rotating potentiometers for setting up voltage analog
- references in the range 0..10 Vdc
- Inner voltage reference obtained via 24 Vdc inner stabilizer
- 24 Digital standard inputs of which 12 special for technologic
- functions (counting, frequency measurement max 60 kHz.
- Digital input simulator with permanent and pulse state
- switchesArchitecture of a PLC, synchronous cycles, asynchronous
- cycles and cycles with priority
- Run-time, cycle time and response time
- Boolean algebra (NO and NC contact, logical functions)
- Programming in AWL, KOP, FUP, GRAPH, SCL languages
- Functions of combinational and sequential logic
- Addressing operationsTimers & counters
- PID control
- Creation of HMI pages
- The software block of PLC simulation enables to test the
- program (OFFLINE) before it is transferred onto the actual
- device. The software is also provided with the following
- examples of exercises carried out:
- Logic gates
- Function modules
- Starting an asynchonous motor
- Reversal of rotation in an asynchronous motor
- Star/delta starting of an asynchronous motor
- Star/delta reversal of rotation
- Linear position control
- Starting a Dahlander motor
- Motor with two separate coils
- Starting an asynchronous wound-rotor motor
- Installation,Commissioning,Operation,
- Testing & Training. must be provided and brand must be mention by the bidder